Renault Klub Slovenija Forum

How do I get into developer mode? (translated from german forum)
- Create a blank USB flash drive with fat32 filesystem
- Create a folder called DEBUG, and in this folder create an empty file called DbgEnable.lge
- put usb in the car
- go to the main menu (with the 6 large icons) Menu> Multimedia> Settings> Photos
- remove previously inserted SD card or USB card in the car
- insert the "new" USB stick and start the engine
- wait at least 30/45 seconds (until "USB drive is ready")
- now you have to press in the black square that you see on the screen (below the two menu items) in the following order: 1 time in the upper left corner (leave at least 1 sec between presses) and tap at least 12 times in the lower right corner (stay within the rectangle)
- if all goes well, the complete R-Link screen will be blank, then you will get a debug mode!

IcEm4n napisal/-a:Če prav razumem, ta DeveloperSide meni "odkleneš" z USB ključem (zasledil v enem drugem videu). Še postopek (c/p iz enega videa):

How do I get into developer mode? (translated from german forum)
- Create a blank USB flash drive with fat32 filesystem
- Create a folder called DEBUG, and in this folder create an empty file called DbgEnable.lge
- put usb in the car
- go to the main menu (with the 6 large icons) Menu> Multimedia> Settings> Photos
- remove previously inserted SD card or USB card in the car
- insert the "new" USB stick and start the engine
- wait at least 30/45 seconds (until "USB drive is ready")
- now you have to press in the black square that you see on the screen (below the two menu items) in the following order: 1 time in the upper left corner (leave at least 1 sec between presses) and tap at least 12 times in the lower right corner (stay within the rectangle)
- if all goes well, the complete R-Link screen will be blank, then you will get a debug mode!

Če bo kdo preizkušal, naj še zapiše, na kateri verziji - ali 2.x ali 3.x.