ojacevalec jbl gto 75.4

[đuro_Pb-g]

mene zanima kak si naj priklopim one lucke ko so v ojacevalcu!?? nevem na kaj naj povezem!?? ce ve kdo naj mi svetuje!

hvala,LP

[FRooTEG]

INSTALLING NEON TUBES
(OPTIONAL)
1. Using a Phillips screwdriver, remove all
screws on the amplifier’s output/power
end panel and set them aside.
2. Using a 3 ⁄32-inch Allen wrench, remove
only the screws on the amplifier’s (top)
clear cover and set them aside.
3. Remove the end panel and slide the
cover off. Set both parts aside.
4. Locate the enclosed hardware bag and
remove the four clips. Each clip has a
square end and a larger round end.
Using a round end, press two clips onto
each neon tube (e.g., Street Glow AN9
or equivalent), as shown in Figure 13.
5. For each tube, align both clips so the
square ends slide onto an exposed
extrusion edge, as shown in Figure 9.
Do not cover any screw holes. When
installed correctly, each neon tube will
sit under an extrusion and not be visible
when viewed from directly above.
6. Route each neon tube’s power cable
through its respective NEON hole on the
end panel (see Figure 13).
7. Slide the cover back into place and reinstall
its screws. Then, replace the end
panel and reinstall its screws.
8. Finish the installation of the neon tubes
as instructed in their owner’s manual.
Figure 12. Control end panel.
GTO75.2 II
GTO75.4 II
GTO301.1II, GTO601.1II, GTO1201.1II
GTO75.6 II


RTFM !!!!!

LP FRooT!

[FRooTEG]

najbols je, da jih pol prklopis na remote ! Sej so mali porabniki, tk da nebi smelo bit problema !

LP FRooT!

[Bojci]

ce pa so vecji porabniki, pa mali rele zraven, katerega krmilis z remote.